CurtPalme.com Home Theater sales, calibration, service, and discussion forum. Hundreds of free manuals & setup tips.
   


 
Sign up and receive the latest newsletters by email!     Join the Forum discussions!    
    Site Map  
Home Products
For Sale
Referral
List
Photo
Gallery
Links Contact
Us
CRT Primer
Troubleshooting Tips
Mounting Methods
Definitive CRT
Projector Setup Guide
Tube/Raster Setup
Tube Condition (Wear)
Advanced Procedures
Projector
Specifications
Projector Rankings
Video Processors
Ampro 1500/2000
Ampro 2300/2600
Ampro 3600/4600
Barco (Older Analog)
Barco 70x/Cine7  
Barco 500/800/801
Barco 808/Cine8
Barco 120x/Cine9
Dwin 500/700
Electrohome ECP 
Mitsubishi
NEC PG
NEC XG
Panasonic 108x
Runco
Seleco
Sony 10xx
Sony 125x/127x
Sony 1292
Sony D50
Sony G70
Sony G90
Zenith 841/851
Zenith 895/900
Zenith 1200


Electrohome Marquee Series

      >> Introduction 
      >> Layout and Setup Tips
      >> Tim Martin Modified LVPS Installation 
      >> Manuals / Downloads




Tim Martin Modified LVPS Installation

 (Page 1)

Page: 1 2 3 4 5

 



Tim Martin (a friendly competitor) offers Marquee noise reduction LVPS modifications to take the already quiet Marquee projector to nearly inaudible levels. For more information about this noise reduction modification, or to make a purchase, see here.

The following procedure illustrates how to remove the LVPS and re-install it once it has been modified by Tim Martin.

The example shown uses a Madrigal MP-9 but also applies to all Electrohome 7xxx/8xxx/9xxx, Vidikron Vision, Madrigal MP, Reference Imaging and Accurate Imaging series projectors. Start by unplugging the power cord from the projector.


1. ACON Removal

If you have the ACON module, you must remove it from the front panel. Remove the three screws holding it to the front panel and unplug it from the top connector.




Next Page ...

 

Copyright CurtPalme.com. All Rights Reserved.