Winterj
Joined: 05 Apr 2006
Posts: 6
Location: Tucson, AZ
|
| Posted: Wed Mar 12, 2008 7:40 am Post subject: Barco 1208/2 Power Mains? |
|
|
Hello All,
So I was enjoying some quality TV with my trusty Barco 1208/2. Then it starts too act funny, dimmed and distorted image, so quick as a flash I shut it down to let it cool off thinking it's been awhile since I cleaned it and maybe it started to overheat. Come back to it several hours later and try to power it up and nothing, no clicks, no whine, no whirring, nothing; DOA. Up to this point I had been using the remote so I tried cycling the mains switch, and again nothing. I drop the covers and find that none of the controller lights are on, and neither the EHT or SMPS led's respond when the power is cycled. I pulled those cards and all the fuses checked out, no obvious damage either. Looking at the diagrams I suspect a Power (Mains) board and I'm curious if anyone else has had issues with this component or has suggestions as to other causes.
Thanx,
Justin
_________________
Remember kids Stop, Drop, and Roll doesn't work in Hell.
|
|
