CurtPalme.com Home Theater Forum

kenwrob · Joined: 21 Jul 2008 Posts: 26

I am upgrading from CRT to Laser. Going with an Epson LS12000 and a Stewart Studiotek 130 G4 16.9 138" diagonal
microperf flying mount screen. Thoughts on how to retire the G90 and a Stewart Studiotek 130 G3 4:3 120" diagonal
microperf screen. They both have been hanging on the ceiling for 15 years. The G90 has 9600 hours on it and am
still using it till new equipment arrives. It does have an issue during warmup that has been happening for years and
goes away after a couple minutes, I will post links to you tube that display the issue. The PJ has a Moome card.

https://www.youtube.com/watch?v=0cIP9G_oSH0

https://www.youtube.com/watch?v=Hq42caGZFYY

I am curious if there is any interest in either of these items, if so I can list them in the for sale section.

I am located in northern Utah.

**kal** · Posted: Sat Oct 28, 2023 1:19 pm Post subject:

Hi! Your post is basically an ad to offer up the G90 already, so I would just post it up in the sale section (for free or close to it) and see what happens! Good luck!

Kal

**Curt Palme** · Posted: Sat Oct 28, 2023 3:44 pm Post subject:

IF the problem is that glitchy flickering, it could be a sync setting in the service menu, or the YA board could be on the way out. At this point the demand for any CRT is almost nonexistent, so as Kal says, list it in the low $100s, or as a freebie on your local Facebook MArketplace or Craigslist.

**kal** · Posted: Sat Oct 28, 2023 4:48 pm Post subject:

You could also post it up for free on the CRT Home Theater Club on Facebook:

https://www.facebook.com/groups/492913890547/

Kal