jaredjaric
Joined: 05 Jun 2007
Posts: 228
Location: Philippines
|
| Posted: Thu Nov 05, 2015 10:21 am Post subject: cine 9 quadrupler failure |
|
|
Hope someone can point me to the right direction.
I have HV issues with my cinemax.
After two splitters ,one eht board and three quads, i am scared of putting in my last quadrupler.
This pj has been having shutdown issues for the past month already.
Smps and h boards were swapped in already , eht boards replaced and 17 volts and P201 raster adjusted as per service manual.
The Pj would run great for four hours then would go into shutdown, bringing down first splitters then an eht board then three quads.
This is becoming a very expensive ordeal for me.
|
|
