CurtPalme.com Home Theater Forum

cd1melton · Joined: 01 Mar 2011 Posts: 9

Anyone know what the green LED to the right of the red scan fail LED is indicating? Says CON (I think) below the LED. I have a couple G2's that that specific LED is not on along with the Convergence power supply LED not being lit. Just wondering what the other LED was indicating. Thanks

barclay66 · Posted: Tue Feb 05, 2013 5:27 pm Post subject:

Hi,

The SF (Scan Fail) LED has two "neighbours". One is the indicator for the presence of the -17V from the SMPS board. The other one indicates the presence of the supply voltage for the Convergence circuits (+CONV) which is generated on the G2 board itself.

So this board has three functions:
- Provides the G2 voltages
- Gives diagnostic output through the LEDs
- Generates the +CONV/-CONV/+FOC voltages for Convergence and Focus

Seems they ran out of space on the SMPS module...

Regards,
barclay66