| Author |
Message |
WESTW
Joined: 03 Apr 2009
Posts: 10
Location: Dumas, Ar.
|
| Posted: Mon May 14, 2012 6:27 pm Post subject: DIFFERENT RESULTS FROM PREVIOUS VID PROC |
|
|
I have just installed Lumagen HDQ in my system. My problem is that I am getting different results than from my previous processor that was a Crystaimage 4.0. I have two DVD players one is a Sony 300+ carousel that has RGB out with 480 p or i switchable. The other is Panasonic VHS to DVD copier with RGB and HDMI out. So far I am running it RGB.
Previously with the Crystalimage I ran the Sony 480i and the Panasonic (don't think it is switchable-it does say it upscales the output, but maybe that's only on HDMI) in and then ran the unit 720p out. I got the same results out of both units. Now with the Lumagen the Sony has a soft picture no matter what I do and the picture jumps every do often. The Panasonic on the other has a killer picture that is easily twice as good as before with no other problems. Any suggestions?
|
|
| Back to top |
|
 |
Rolls-Royce
Joined: 30 Sep 2007
Posts: 288
Location: Victorville, CA
|
| Posted: Sat Oct 13, 2012 5:40 pm Post subject: |
|
|
Is the Sony on a short (< 6 foot) HDMI cable? Lumagen recommends 6 foot or better cables for best HDMI signal transmission and recovery.
_________________
....Royce....
|
|
| Back to top |
|
|
Nashou66
Joined: 12 Jan 2007
Posts: 16171
Location: West Seneca NY
|
|
| Back to top |
|
|
|
|
