| Author |
Message |
jantje112
Joined: 17 Jul 2006
Posts: 328
|
| Posted: Sat Jun 25, 2011 10:11 pm Post subject: anyone in europe repairing my crystalio II? |
|
|
My 9500ultra and the crystalio II where good friends. The crystalio suddenly stopped working.
unit looks fine, powers up but won't give a picture on hdmi 1 or 2. tested other displays on it. Anyone who have experience with the units? PMS stopped support years back...
|
|
| Back to top |
|
 |
HK-Steve
Joined: 15 Jul 2006
Posts: 849
Location: Switzerland
TV/Projector: Marquee 9500, Epson 8100
|
| Posted: Sun Jun 26, 2011 6:26 am Post subject: |
|
|
Where abouts are you located??
Think that the board itself is faulty, as I know of 2 units here in Switzerland, same problem.
Cheers
Steve
_________________
|
|
| Back to top |
|
|
jantje112
Joined: 17 Jul 2006
Posts: 328
|
| Posted: Sun Jun 26, 2011 10:29 am Post subject: |
|
|
| HK-Steve wrote: | Where abouts are you located??
Think that the board itself is faulty, as I know of 2 units here in Switzerland, same problem.
Cheers
Steve |
I'm from the netherlands (holland)
The unit looks to work fine in every way, the display works, the remote works but no picture. There is some sort of signal on the hdmi, because the hdmi switch detects a source/connection when power on. My 50" plasma gave an " unknown signal " error and vga, well I'm going to test that later today.
|
|
| Back to top |
|
|
jantje112
Joined: 17 Jul 2006
Posts: 328
|
| Posted: Sun Jun 26, 2011 11:30 am Post subject: |
|
|
Well,
did a test on the rgbhv output of the CII, and it's working on that output without any problems. The crystalio even seems to recognize a handshake with my hdmi on the samsung, because it's displaying "SAMSUNG" on the output OSD in the menu.
Is there something that can cause this problem?
|
|
| Back to top |
|
|
|
|
