CurtPalme.com Home Theater Forum

[Adverse Effects]

ok got my new PG9 Xtra it powers up nicely

useing a torch looking through the lenses red and blue tubes are clean and green only has the slightest faint mark/line at the bottom it (almost didn't see it)

still waiting on the other box of stuff that comes with it all the manual's from new workshop one and what looks like a full remote as well

i dont know if its me or not but i carnt seem to get it to show a pic from the inputs (built in menu system works fine)

2 VGA 1 comp 1 svid and a set of the normal 5 or 6 BNC's

have tried all but the BNC's (dont have a cable) and none of them would put a pic on the screen
any idears?

i am thinking i may need the remote to change things

unit cost me $82 and the shipping cost $156.18 go figger

its so dam expencive to move things around Australia

[EDIT] it has a point board in it to i think as all 4 slots are full

[Curt Palme]

You absolutely need the remote to do anything on this set. The composite video board may not be installed in the set, so the video/Svideo inputs may be dead. I do have those remotes.

[Curt Palme]

You absolutely need the remote to do anything on this set. The composite video board may not be installed in the set, so the video/Svideo inputs may be dead. I do have those remotes.