| Author |
Message |
vidikron1984
Joined: 19 May 2010
Posts: 20
|
| Posted: Sun May 23, 2010 3:04 pm Post subject: ECP 4500 getting minor convergence drift every few days... |
|
|
ECP 4500 getting minor convergence drift every few days...
its not too much of a drift... just enough to bug me... ideas?
_________________
Vidikron VPF50HD
|
|
| Back to top |
|
 |
vidikron1984
Joined: 19 May 2010
Posts: 20
|
| Posted: Sun May 23, 2010 9:52 pm Post subject: |
|
|
any ideas?
_________________
Vidikron VPF50HD
|
|
| Back to top |
|
|
vidikron1984
Joined: 19 May 2010
Posts: 20
|
| Posted: Mon May 24, 2010 1:32 pm Post subject: |
|
|
I figure its something electronic... I have tons of extra boards to try out... just would like to know
_________________
Vidikron VPF50HD
|
|
| Back to top |
|
|
draganm
Joined: 08 Mar 2006
Posts: 8990
Location: Colorado
|
| Posted: Mon May 24, 2010 3:11 pm Post subject: |
|
|
|
Well the obvious candidate is the convergence board. An typical untouched Marquee will do the same thing and it's a much better machine. Not many people messing with ECP's anymore.
|
|
| Back to top |
|
|
LOTREE
Joined: 19 Mar 2006
Posts: 401
Location: Paradise, Newfoundland
|
| Posted: Mon May 24, 2010 4:40 pm Post subject: |
|
|
I always assumed it was due to the Dallas chip but that doesn't seem to be the case after swapping it. I'm not sure if there are any mods that can be done on the convergence board. There's more info in the archives on AVS than here about ECP's so you may be able to dig something up.
_________________
Zenith Pro 1200x | Electrohome ECP 4500 | Yamaha HTR-5740 | HTPC & Speaker build to follow
|
|
| Back to top |
|
|
|
|
