| Author |
Message |
Corleone88
Joined: 09 Dec 2006
Posts: 474
Location: France
|
| Posted: Sat Jul 05, 2008 9:58 am Post subject: Barco 808 and signal recognition |
|
|
Hi,
Does someone know which board is responsible of detecting the frequencies of the video signal?
When the signal is recognized, the frequencies are displayed in the right bottom corner of the screen.
For example : 75KHz
75Hz
I would like to know which board manages the displayed values.
I ask this question because I suspect my Barco to not recognize the signals above around 65KHz very well.
Above this frequency, it always displays 75KHz (horiz. freq) and 75Hz (vert. freq).
I used a HTPC with the HDFury. I did some tests on a PC screen, and I am pretty sure the problem comes from m Barco 808
|
|
| Back to top |
|
 |
Tom.W
Joined: 09 Mar 2006
Posts: 6635
|
| Posted: Sat Jul 05, 2008 4:54 pm Post subject: |
|
|
|
The on screen display is provided by an eprom located on the system controller board but I doubt the problem is with the Barco without more information...
|
|
| Back to top |
|
|
Corleone88
Joined: 09 Dec 2006
Posts: 474
Location: France
|
| Posted: Sat Jul 05, 2008 6:33 pm Post subject: |
|
|
|
Ok, but where the controller gets this information ? The RGB switcher ?
|
|
| Back to top |
|
|
|
|
