| Author |
Message |
Willie
Joined: 13 May 2006
Posts: 169
Location: Green Bay
|
| Posted: Mon Sep 03, 2007 8:09 pm Post subject: G2 Bias on a P17 modded Marquee |
|
|
I am putting P17's in a 9500LC (finally, I have had them and the chassis for months). Pretty sure Terry sent me an email about what pin the G2 bias connects to, but I don't have it and can't remember. I thought it was pin 6 that comes through the modded neck card.
Before I end up smokin' a tube, can someone confirm what pin the G2 bias is connected to?
Thanks,
Willie
|
|
| Back to top |
|
 |
erikjohn
Joined: 08 Mar 2006
Posts: 636
Location: Florida
|
|
| Back to top |
|
|
cmjohnson
Joined: 03 Apr 2006
Posts: 5180
Location: Buried under G90s
|
| Posted: Mon Sep 03, 2007 9:55 pm Post subject: |
|
|
 \
Yep, that's it. Pin 6. Remove the socket, drill out the hole. The whole G2 lead and boot goes through the hole to connect
solidly to the G2 pin's full length. As this is a CRITICAL connection, don't settle for less than full engagement of the pin socket
on the pin body.
CJ
|
|
| Back to top |
|
|
|
|
