CurtPalme.com Home Theater Forum

wassup30 · Joined: 14 Jun 2017 Posts: 30

From what I can see it's the higher resolution tubes.

However now I'm having a completely other problem! (I know right .... lol)

I get a 66 Error on the back of the projector and every time I try and start it up it'll fake like it's going to boot up and then turn off again. I just tried opening it up and reseated all the connections. Still a no go.

Any ideas?

cmjohnson · Joined: 03 Apr 2006 Posts: 5180 Location: Buried under G90s

66 error, not a red 88?

Red 88 means a bad YA board. That's the brain. Craig can rebuild it but it's kind of expensive. However, I've been able to barter with
him for getting those rebuilt for me. I might be able to get you a deal if the YA board needs repair.

I want to see you get that thing working!

Oh, make sure that you reconnected all three of the ground leads to the tabs on the lenses. It won't start up if those aren't all connected but I don't remember what error that gives.

wassup30 · Joined: 14 Jun 2017 Posts: 30

All three grounds are connected. Also i looked inside the high voltage connector and the lead we had spoken about in PMs was not still in there.

and yes its a yellow 66 error that stays illuminated on the back.

This thing is frustrating I just want to watch some GOT lol :--P