htguy1
Joined: 30 Jul 2008
Posts: 99
|
| Posted: Mon Jan 19, 2015 5:10 am Post subject: Marquee VIM bypassing the relays? |
|
|
Hi,
So I am using the Moome V3 HDMI card that uses input 2 on my Marquee VIM and I was looking at the signal route from the output opamps on the Moome card to the relays and it looks like there are a bunch of areas where proper impedence is impossible to keep. That led to wonder if there is a good reason I can't just pickup the R G B output from the opamps on the card and send that output directly to the resistor that is right after both relays? (I have no plans to use the RGBHV input one again)
Thanks
God bless...
Mark
|
|
