| Author |
Message |
damian
Joined: 13 Jul 2013
Posts: 25
Location: geraldton western australia
|
| Posted: Sat Jul 13, 2013 2:01 am Post subject: please help need information loading blocks barco 808 |
|
|
hi all
I am chasing any information on loading and saving blocks to the projector I have deleted all the blocks from its memory
I have a good source feeding the projector threw the rgb port but still projector says no source.how ever I also have the projector linked to my pc with the barco software programme running and I can select the source from there and then I get a picture on the projector but once I switch machine of its like it doesn't remember and cant find the source again.
Projector itself is working fine after some repairs replaced quadrupeler also had a sh*tty solder joint on one of the boards
machine did experience a possible spike when solder joint blew apart and melted quad.so to sum it up I can select source from computer works fine switch off machine then back on again and it does not recognise source
|
|
| Back to top |
|
 |
CasetheCorvetteman
Joined: 09 Nov 2008
Posts: 6326
Location: Australia
|
| Posted: Sat Jul 13, 2013 4:34 pm Post subject: |
|
|
|
Did you try pressing 4 or 5 on the remote for the Port 4/5 selection? Or press 3 if youre feeding into port 3
|
|
| Back to top |
|
|
damian
Joined: 13 Jul 2013
Posts: 25
Location: geraldton western australia
|
| Posted: Sun Jul 14, 2013 12:43 am Post subject: |
|
|
|
hi corvetteman yep tried that and it works hahah I got it all sorted now cheers
|
|
| Back to top |
|
|
CasetheCorvetteman
Joined: 09 Nov 2008
Posts: 6326
Location: Australia
|
| Posted: Sun Jul 14, 2013 4:38 am Post subject: |
|
|
|
No worries mate, not that i knew what i was doing til about 3 hours before i posted that, but i had to dig through the Cine 9 manual to find it!
|
|
| Back to top |
|
|
damian
Joined: 13 Jul 2013
Posts: 25
Location: geraldton western australia
|
| Posted: Sun Jul 14, 2013 11:52 am Post subject: |
|
|
|
yeh I had also read threw the manual before I seen your post and worked it out.But now after all that I tuned the picture and done all the convergence and got the picture looking reasonable,so I started to tidy every thing up put wires in roof etc and now I cant get a good signal from the hdmi to rgb convertor feeding the projector after playing with this for the last day and a half I am 99% sure that the convertor is faulty it is a hd fury 2
|
|
| Back to top |
|
|
CasetheCorvetteman
Joined: 09 Nov 2008
Posts: 6326
Location: Australia
|
| Posted: Sun Jul 14, 2013 12:34 pm Post subject: |
|
|
|
Check all the connections.
|
|
| Back to top |
|
|
|
|
