| Author |
Message |
digitalayon
Joined: 02 Mar 2009
Posts: 921
|
| Posted: Thu Mar 01, 2012 4:31 pm Post subject: anyone know where the CLM battery is on a vision 1? |
|
|
|
Some of my convergence settings did not take the other night....wondering if I didn't let it warm up enough before I started. I'll admit...it was 5 minutes....Either that or the CLM battery is starting to die.
|
|
| Back to top |
|
 |
Tim in Phoenix
Joined: 21 Oct 2006
Posts: 4409
Location: Phoenix
|
| Posted: Thu Mar 01, 2012 4:40 pm Post subject: |
|
|
Hello
It is the square orange device on the control board, Renata 175-0. Were you adjusting a locked memory?
.
|
|
| Back to top |
|
|
digitalayon
Joined: 02 Mar 2009
Posts: 921
|
| Posted: Thu Mar 01, 2012 5:17 pm Post subject: |
|
|
| Tim in Phoenix wrote: | Hello
It is the square orange device on the control board, Renata 175-0. Were you adjusting a locked memory?
. |
Not sure....just sorta playing around....can't really to complete adjusting until I know what I want to do. The issue is I am torn between floor or ceiling. I only have a 6'8 ceiling in the basement. So I'm probably going floor since this unit is quite a bit larger in height compared to the NEC/Runco unit I had previously. Going to have to make a cover for it when it is not in use. Kids will kill the thing in a week!!!
|
|
| Back to top |
|
|
|
|
