| Author |
Message |
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Fri Jul 23, 2010 3:33 am Post subject: |
|
|
thanks for that ill give them all a try.
well i have the fury 3 in my hand and 7 and 8 are turned off the gamma x was set to inv
but looking at the fury 3 i noticed that the 3 switch is on and the pj says negative sync
the fury settings are as follows
1 on 2off 3,4,5,6 on 7,8 off
_________________
We are ALL job creators !
|
|
| Back to top |
|
 |
AnalogRocks
Forum Moderator
Joined: 08 Mar 2006
Posts: 26706
Location: Toronto, Ontario, Canada
TV/Projector: Sony 1252Q, AMPRO 4000G
|
| Posted: Fri Jul 23, 2010 3:40 am Post subject: |
|
|
turn DIP 2 on and DIP 5 off and leave the GammaX set to INV and try again
_________________
Tech support for nothing
CRT.
HD done right!
|
|
| Back to top |
|
|
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Fri Jul 23, 2010 3:43 am Post subject: |
|
|
going to try it now back in a few minutes with a progress report
thanks
_________________
We are ALL job creators !
|
|
| Back to top |
|
|
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Fri Jul 23, 2010 4:12 am Post subject: |
|
|
well, as far as i can tell the bd is fine.
the ts-160 when it is in 1080i mode gives a unbelievable picture for about 60-70 seconds then flashes blank and comes back on.
thr pj asked if i wanted to save this new setting it recognized. so i did.
_________________
We are ALL job creators !
|
|
| Back to top |
|
|
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Fri Jul 23, 2010 4:15 am Post subject: |
|
|
by the way NICE CHARGER ! i had a 71 challenger ragtop (totaled it ) now i have a 2008 srt challenger i miss my 71 though.
_________________
We are ALL job creators !
|
|
| Back to top |
|
|
AnalogRocks
Forum Moderator
Joined: 08 Mar 2006
Posts: 26706
Location: Toronto, Ontario, Canada
TV/Projector: Sony 1252Q, AMPRO 4000G
|
| Posted: Fri Jul 23, 2010 5:04 am Post subject: |
|
|
So you do have a working picture now?
_________________
Tech support for nothing
CRT.
HD done right!
|
|
| Back to top |
|
|
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Fri Jul 23, 2010 1:25 pm Post subject: |
|
|
sorry so long on reply, it was 1 am here when i finally turned in. I DO SEEM TO HAVE a good picture on the bd although i really need to watch it awhile longer to be sure. THE TS-160 TUNER is another story it will give me a great picture in 1080i mode for about 60 seconds then it will flash blank and come back on and repeat this process over and over. it will hold a picture in 720 mode but the 1080 is soooooo much better i dream about watching football on that screen in 1080i.
_________________
We are ALL job creators !
|
|
| Back to top |
|
|
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Fri Jul 23, 2010 4:24 pm Post subject: |
|
|
well, i disconnecter the ts-160 and hooked it up to my sony tv , just to make sure it wasnt the dvi-hdmi adapter or the ts-160 itself. IT worked perfectly so now i will hook it back up to the zenith and try again any suggestions would be appreciated , i am at a loss. i will be online until midnight eastern time praying for help. HELP !!!
thanks jeff
_________________
We are ALL job creators !
|
|
| Back to top |
|
|
ecrabb
Forum Moderator
Joined: 13 Mar 2006
Posts: 15909
Location: Utah
TV/Projector: JVC RS40, Epson 5010
|
| Posted: Sat Jul 24, 2010 12:01 am Post subject: |
|
|
Hey, Jeff... Sorry, but I deleted your other two posts relating this one issue... The multiple posts don't really serve any purpose, they litter the forum, and more importantly, anybody who might contribute to helping solve your problem loses all the history.
OK, back to the Samsung...That OTA receiver definitely isn't capable of outputting 24fps - nothing did at that time.
How's it connected to your projector? DVI-HDMI to Fury 3 to projector?
SC
|
|
| Back to top |
|
|
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Sat Jul 24, 2010 12:16 am Post subject: |
|
|
FOUND YOUR POST YES DVI-HDMI TO MONOPRICE SWITCHER TO FURY 3 TO PJ
_________________
We are ALL job creators !
|
|
| Back to top |
|
|
ecrabb
Forum Moderator
Joined: 13 Mar 2006
Posts: 15909
Location: Utah
TV/Projector: JVC RS40, Epson 5010
|
| Posted: Sat Jul 24, 2010 1:53 am Post subject: |
|
|
OK, so the BD player works fine now, but the Samsung OTA receiver still doesn't? Hmmm... That is weird.
So, do you know which one of the things Jeremy had you try corrected the situation with the BD player?
Also, when the picture is flashing on and off, is the blue light on the HD Fury doing anything?
SC
|
|
| Back to top |
|
|
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Sat Jul 24, 2010 1:58 am Post subject: |
|
|
THE BD HDMI CABLE WAS LOOSE.
THE 160 ACTS LIKE IT IS TRYING TO HANDSHAKE WITH THE FURY 3
F3 FLASHES CONSTANTLY
_________________
We are ALL job creators !
|
|
| Back to top |
|
|
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Sat Jul 24, 2010 2:01 am Post subject: |
|
|
THE TS 160 WONT WORK ON ANY SETTING NOW 480 720 OR 1080
PICTURE JUST FLASHES IN AND OUT EVERY 15 SECONDS OR SO
_________________
We are ALL job creators !
|
|
| Back to top |
|
|
AnalogRocks
Forum Moderator
Joined: 08 Mar 2006
Posts: 26706
Location: Toronto, Ontario, Canada
TV/Projector: Sony 1252Q, AMPRO 4000G
|
| Posted: Sat Jul 24, 2010 2:31 am Post subject: |
|
|
Jeff when did you purchase your HDfury3?
_________________
Tech support for nothing
CRT.
HD done right!
|
|
| Back to top |
|
|
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Sat Jul 24, 2010 2:35 am Post subject: |
|
|
APRIL I THINK
_________________
We are ALL job creators !
|
|
| Back to top |
|
|
AnalogRocks
Forum Moderator
Joined: 08 Mar 2006
Posts: 26706
Location: Toronto, Ontario, Canada
TV/Projector: Sony 1252Q, AMPRO 4000G
|
| Posted: Sat Jul 24, 2010 4:13 am Post subject: |
|
|
PM me the email address you placed your order with
_________________
Tech support for nothing
CRT.
HD done right!
|
|
| Back to top |
|
|
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Sat Jul 24, 2010 4:18 am Post subject: |
|
|
WELLYOU ARE NOT GONNA BELIEVE THIS. I OPENED THE COVER ON THE FURY 3 TURNED 1 AND 2 OFF THEN TURNED 1 BACK ON AND PRESTO ! 1080I WHAT A PICTURE! I SAT IN AMAZEMENT FOR 30 MINS GOING THROUGH THE CHANNELS NOT BELIEVING MY EYES. THEN I GOT THE BRIGHT IDEA TO SEE IF THE BD WOULD STILL WORK.(IT DID) WOW I THOUGHT HOW COOL IS THIS. THEN I CHANGED THE MONOBOX SWITCHER BACK TO THE TS-160 AND IT WAS RIGHT BACK TO THE WAY IT WAS BEFORE , FLASHING IN AND OUT.WHAAAAATTTTT THE . ANYWAY I WENT BACK TO THE BD IT WAS STILL WORKING FINE. SO I TURNED OFF THE BD FLIPPED THE 2 DIPSWITHES AND THEN FLIPPED THEM BACK IN THE SAME SEQUENCE AS BEFORE AND PRESTO 1080I TV. AS LONG AS I ONLY WATCH TV ITS OK BUT I GOT A FEELING IM GONNA WEAR OUT THOSE LITTLE SWITHES.
_________________
We are ALL job creators !
|
|
| Back to top |
|
|
AnalogRocks
Forum Moderator
Joined: 08 Mar 2006
Posts: 26706
Location: Toronto, Ontario, Canada
TV/Projector: Sony 1252Q, AMPRO 4000G
|
| Posted: Sat Jul 24, 2010 4:22 am Post subject: |
|
|
Jeff, please TURN OFF THE CAPS LOCK ITS REALLY HARD TO READ WHAT YOU ARE TYPING. Thanks
Please PM me your email address you ordered with.
_________________
Tech support for nothing
CRT.
HD done right!
|
|
| Back to top |
|
|
jeffslife
Joined: 17 Apr 2010
Posts: 4190
Location: ohio usa
|
| Posted: Sat Jul 24, 2010 4:26 am Post subject: |
|
|
sorry about the caps.pm the address to you did you get it?
_________________
We are ALL job creators !
|
|
| Back to top |
|
|
AnalogRocks
Forum Moderator
Joined: 08 Mar 2006
Posts: 26706
Location: Toronto, Ontario, Canada
TV/Projector: Sony 1252Q, AMPRO 4000G
|
| Posted: Sat Jul 24, 2010 4:36 am Post subject: |
|
|
| jeffslife wrote: | | sorry about the caps.pm the address to you did you get it? |
Yes. I'm looking into which firmware you have
_________________
Tech support for nothing
CRT.
HD done right!
|
|
| Back to top |
|
|
|
|
