| Author |
Message |
Ben851
Joined: 13 Sep 2008
Posts: 221
Location: Ottawa, Ontario
|
| Posted: Sun Apr 25, 2010 6:05 pm Post subject: XG 135(AC) Dancing Blue! |
|
|
Hey Fellas,
I pulled out my XG for shits and giggles this weekend, and have noticed while converging it that the blue image is fluctuating in size... almost dancing back and forth.
Now I was only doing a very hasty setup, so I had to use a lot of electronic adjustment to make up for my less than stellar mechanical placement - would this possibly just be a case of over-taxing the convergence controls or is this a sign of something getting ready to die?
Thanks
Ben
_________________
Thanks,
Ben
|
|
| Back to top |
|
 |
Curt Palme
CRT Tech
Joined: 08 Mar 2006
Posts: 24396
Location: Langley, BC
TV/Projector: All of them!
|
| Posted: Sun Apr 25, 2010 8:19 pm Post subject: |
|
|
|
Your HV lead is loose in the HV splitter. Reseat it, and I'll bet it will go away. that's assuming it fluctuates both in an H and V direction. If it's the H direction only, then clean and reseat the H yoke leads on the H deflection board.
|
|
| Back to top |
|
|
Mark_A_W
Joined: 15 Mar 2006
Posts: 3068
Location: Sunny Melbourne Australia
|
| Posted: Mon Apr 26, 2010 7:37 am Post subject: |
|
|
Yep, Deflection Coil/Yoke leads on the Def board.
Common issue.
|
|
| Back to top |
|
|
Ben851
Joined: 13 Sep 2008
Posts: 221
Location: Ottawa, Ontario
|
| Posted: Mon Apr 26, 2010 11:30 am Post subject: |
|
|
Thanks guys, I reseated the connectors on the deflection board and giggled the HV lines on the splitter. To actually take off the HV lines, are they a bayonet style connector like on a Marquee?
Anyways, this seemed to take care of the problem for the most part - I still have some wiggly test patterns (I seem to recall this being a flaw with all XGs?)
_________________
Thanks,
Ben
|
|
| Back to top |
|
|
|
|
