Roddyjoe
Joined: 13 Dec 2008
Posts: 9
|
| Posted: Sat Dec 13, 2008 8:39 am Post subject: Seleco 420hb won't program |
|
|
Several of my banks were deleted, including the NSTC bank. When I send it a VCR NSTC signal, it shows no picture and it automatically loads a bank that is not even close to what I need. How do I re-program in a new bank? The manual says that a new bank can be programmed in, but when I follow the instructions it does not automatically pull up a bank with the proper vertical and horizontal frequencies and it won't let me change those.
I am willing to even do a factory reset and start from scratch, if it has one, but the manual does not give instructions on how to reset the projector.
Can anyone help me?
Thanks
Rod
|
|
