| Author |
Message |
stefuel
Joined: 07 Mar 2006
Posts: 3353
Location: Green Harbor MA USA
|
| Posted: Sun Sep 21, 2008 1:31 pm Post subject: Quick ECP question |
|
|
I'm putting a ECP 3101 together for my brother to use. I can't find my manual and have run into a minor stumbling block. I've got it up and running with the scan set for table/front projection. The image is correct but the converg controls are backwards. Up is down and left is right. It's been years since I've worked on a ECP and can't remember how to correct this. Thanks,
_________________
Chip
A Barco is only a AmPro with training wheels
Card carrying member of the AVS chain gang.
|
|
| Back to top |
|
 |
Tim in Phoenix
Joined: 21 Oct 2006
Posts: 4409
Location: Phoenix
|
| Posted: Sun Sep 21, 2008 4:33 pm Post subject: |
|
|
Hey Chip
Look in the menus for Mounting Position, and select front floor.
.
|
|
| Back to top |
|
|
stefuel
Joined: 07 Mar 2006
Posts: 3353
Location: Green Harbor MA USA
|
| Posted: Sun Sep 21, 2008 4:50 pm Post subject: |
|
|
| Tim in Phoenix wrote: | Hey Chip
Look in the menus for Mounting Position, and select front floor.
. |
Thanks Tim. I didn't have it setup on a screen while working on it. It's on it's way to the final location for mounting. It's going to be hung now so I may not have to change it.
_________________
Chip
A Barco is only a AmPro with training wheels
Card carrying member of the AVS chain gang.
|
|
| Back to top |
|
|
|
|
