| Author |
Message |
stuffandpuff
Joined: 30 Jul 2008
Posts: 69
|
| Posted: Sat Aug 09, 2008 2:11 pm Post subject: G70 Setting factory defaults. Gain settings Blue tube |
|
|
After noticing gray scale was too blue. I checked the gain settings for each tube and the blue was at max. I then decided to reset each tube to it's factory default setting . I cleared all service and user settings etc and reset to the factory defaults and was surprised to see that the blue defaults to MAX. Is this normal?
Also, understanding that the condition of the tubes effect these settings, so know two G70s will be set exactly the same but just to get an idea and a place to start, Can anyone share their gain settings for each tube?
One last question, Is there a way to restore all settings to factory defaults at once, similar to the red button on an ECP 4XXX?
Thanks!
|
|
| Back to top |
|
 |
AFryia
Joined: 09 Mar 2006
Posts: 965
Location: S.E. Michigan VPH-G70Q
|
| Posted: Sun Aug 10, 2008 2:41 am Post subject: |
|
|
Based on the manual Green is set to MAX and Blue Red adjusted accordingly.
This is also my personal experience. With my last grey scale calibration at the end I tweaked green to ~250 or so!
_________________
My Volt Blog
|
|
| Back to top |
|
|
stuffandpuff
Joined: 30 Jul 2008
Posts: 69
|
| Posted: Sun Aug 10, 2008 3:25 am Post subject: |
|
|
Thank you.
I didn't write the numbers down but when I reset, Blue goes to max and green and red are well below 250.
Strange.
Last edited by stuffandpuff on Tue Aug 12, 2008 6:00 pm; edited 1 time in total
|
|
| Back to top |
|
|
mike calcott
Joined: 18 May 2006
Posts: 307
Location: Australia
|
| Posted: Sun Aug 10, 2008 3:48 am Post subject: Bias Gain |
|
|
Here is an extract from the G70 service manual, it might help
| Description: |
|
| Filesize: |
363.71 KB |
| Viewed: |
1676 Time(s) |
|
_________________
Old dog learning new tricks
|
|
| Back to top |
|
|
AFryia
Joined: 09 Mar 2006
Posts: 965
Location: S.E. Michigan VPH-G70Q
|
| Posted: Sun Aug 10, 2008 4:36 pm Post subject: |
|
|
| stuffandpuff wrote: | Thank you.
I didn't right the numbers down but when I reset, Blue goes to max and green and red are well below 250.
Strange. |
I remember an earlier post that said the 12XX series PJ used to set Blue to MAX.
|
|
| Back to top |
|
|
stuffandpuff
Joined: 30 Jul 2008
Posts: 69
|
| Posted: Tue Aug 12, 2008 5:59 pm Post subject: |
|
|
|
Thank you Mike!
|
|
| Back to top |
|
|
|
|
