audvid
Joined: 14 May 2008
Posts: 25
|
| Posted: Fri Jul 25, 2008 4:46 pm Post subject: Marquee 9500 Calibration Newbie.. primal questions.. |
|
|
I have a marquee 9500 Ultra.
My first attempt at setting it up. Hence, please pardon me if my questions are too basic.
green horizontal and vertial lines are level horzontally and vertically - as compared to a horizontal auto leveling laser beam.
On the blue grid, horizontal lines are parallel to green but the vertical lines are not parallel to the green lines but they are straight lines. Actually, even the Red vertical lines are not parallel to the others either.
Which ones do I need to adjust for this alignment? - Mechanically? Can this be done Electronically also?
Is it safe to touch the scan yoke or focus coils while the projector is ON - as long as I don't touch the red HV wire?
|
|
