Link Posted: Thu Feb 25, 2016 11:20 am Post subject: Back to CRT - BD808s raster Setup question
BD808s P16 blue/red PT18 Green. HD117-24 lenses.
I stumbled upon this projector + spares + HDFury cheap so I'm back in the CRT game. Right now it's up on the ceiling, still have to square it to the screen. Now I have a question which I have always had and can't seem to figure out.
How do I make sure the rasters are setup correct? Right now I can see the top and bottom of the raster but not the sides. Using installation I can move the raster and see the sides (at the very end of the correction-range so 10 and 90 left/right)
Is it ok like this? Do I need to tweak the raster? I could reduce the size by using the master width trimpot on the SMPS sub board.
Go into the geometry menu and set the H width to 50%. Put up the test grid (genlocked test pattern) and set this trimpot so that the test pattern _just_ overshoots the sides of the tubes
I checked this and that's exactly how it has been setup.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum