CurtPalme.com Home Theater Forum

emmamillathompson · Guest

As I was watching my G90 tonight for a couple of hours, I heard a pop and the picture went out. Error code 61 was set (200V line). The remote was inactive and the fans were all shut down as well.
What should I look for? A suggestion for the next step?

HaydnG90 · Joined: 22 May 2006 Posts: 1335

Don't know if its the same cause but a good place to start. A cracked green tube will result in what you heard and error 61

http://www.curtpalme.com/forum/viewtopic.php?p=477229

How old is your Dallas chip?

**Curt Palme** · Posted: Wed Dec 19, 2018 2:48 pm Post subject:

Yes, look into all three lenses with the set off, and see if you can see a crack across any of the tube faces.

barclay66 · Posted: Wed Dec 19, 2018 8:40 pm Post subject:

Hi,

You could have a short on the +200V Line on the PA board. This would happen if one or more of the big switching MOSFETS was fried...

Kind Regards,
barclay66

HaydnG90 · Joined: 22 May 2006 Posts: 1335

I think we have a Troll in our midst.

Check this post from 2009. OP is same word for word
https://www.avsforum.com/forum/16-crt-projectors/1125709-i-need-g90-guru-pop-no-picture.html

gjaky · Joined: 05 Jun 2010 Posts: 2790 Location: Budapest, Hungary

**Curt Palme** · Posted: Thu Dec 20, 2018 7:50 pm Post subject:

She is dead now. Very Happy

HaydnG90 · Joined: 22 May 2006 Posts: 1335

woohoo.

Just a Guest Troll and not an official one. Funny how the Troll arrived from AVS. I have my suspicions.

km987654 · Posted: Fri Dec 21, 2018 8:17 am Post subject:

Girl Troll