View previous topic :: View next topic |
Author |
Message |
ameltvedt
Joined: 27 Nov 2018 Posts: 13 Location: North Carolina
|
Link Posted: Tue Nov 27, 2018 10:54 pm Post subject: Need boards for Barco Graphics 800 |
|
|
Does anybody have parts for a Barco 800 ? Have a red scan fail light and suspect horizontal board 761766 and/or vertical board 761768. Thanks
|
|
Back to top |
|
|
ameltvedt
Joined: 27 Nov 2018 Posts: 13 Location: North Carolina
|
Link Posted: Wed Dec 05, 2018 12:25 am Post subject: |
|
|
Has anybody attempted to repair one of these boards when no replacements are available? I have changed a few resistors and zeners (z6, z303, z305) in the scan fail circuit on the horizontal board without any success. I still have a red scan fail light, the HTHD light is out, and the D23 led "hold down" on the horizontal board is lit. This seems to be a common failure on Barco 800, I am hoping someone has resolved it and can give me some guidance before my theater retires to a fourth bedroom.
Thanks
|
|
Back to top |
|
|
Curt Palme CRT Tech
Joined: 08 Mar 2006 Posts: 24305 Location: Langley, BC
TV/Projector: All of them!
|
Link Posted: Wed Dec 05, 2018 4:53 pm Post subject: |
|
|
On the V boards, it's usually the output chips, on the H board it's usually the MOSFET transistors. Best thing is to use an oscilloscope for the chips to see if they are outputting the vertical sweep, with the H board, just test the MOSFETS on the heatsink for shorts.
|
|
Back to top |
|
|
|
|