Return to the CurtPalme.com main site CurtPalme.com Home Theater Forum
A forum with a sense of fun and community for Home Theater enthusiasts!
Products for Sale ] [ FAQ: Hooking it all up ] [ CRT Primer/FAQ ] [ Best/Worst CRT Projectors List ] [ Setup Tips & Manuals ] [ Advanced Procedures ] [ Newsletters ]

 
Forum FAQForum FAQ   SearchSearch   MemberlistMemberlist  Photo AlbumsPhoto Albums  RegisterRegister 
 MembershipClub Membership   ProfileProfile   Private MessagesPrivate Messages   Log inLog in 
Blu-ray disc release list and must-have titles. Buy the latest and best Blu-ray titles to show off in your home theater!

Need boards for Barco Graphics 800

 
Post new topic   Reply to topic   Printer-friendly view    CurtPalme.com Forum Index -> CRT Projectors
View previous topic :: View next topic  
Author Message
ameltvedt



Joined: 27 Nov 2018
Posts: 13
Location: North Carolina


PostLink    Posted: Tue Nov 27, 2018 10:54 pm    Post subject: Need boards for Barco Graphics 800 Reply with quote


        Register to remove this ad. It's free!
Does anybody have parts for a Barco 800 ? Have a red scan fail light and suspect horizontal board 761766 and/or vertical board 761768. Thanks
Back to top
ameltvedt



Joined: 27 Nov 2018
Posts: 13
Location: North Carolina


PostLink    Posted: Wed Dec 05, 2018 12:25 am    Post subject: Reply with quote

Has anybody attempted to repair one of these boards when no replacements are available? I have changed a few resistors and zeners (z6, z303, z305) in the scan fail circuit on the horizontal board without any success. I still have a red scan fail light, the HTHD light is out, and the D23 led "hold down" on the horizontal board is lit. This seems to be a common failure on Barco 800, I am hoping someone has resolved it and can give me some guidance before my theater retires to a fourth bedroom.

Thanks
Back to top
Curt Palme
CRT Tech


Joined: 08 Mar 2006
Posts: 23729
Location: Langley, BC

TV/Projector: All of them!


PostLink    Posted: Wed Dec 05, 2018 4:53 pm    Post subject: Reply with quote

On the V boards, it's usually the output chips, on the H board it's usually the MOSFET transistors. Best thing is to use an oscilloscope for the chips to see if they are outputting the vertical sweep, with the H board, just test the MOSFETS on the heatsink for shorts.
Back to top
Display posts from previous:   
Post new topic   Reply to topic   Printer-friendly view    CurtPalme.com Forum Index -> CRT Projectors All times are GMT
Page 1 of 1
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum