View previous topic :: View next topic |
Author |
Message |
CSX
Joined: 11 Feb 2015 Posts: 142 Location: Ohio
|
Link Posted: Sat Mar 07, 2015 3:57 pm Post subject: Marquee 9500LC convergence issue |
|
|
So last night, I moved the projector from the floor to the ceiling after alots of preparation and tests.
After installation the projector was behaving strangely. (Green and blue would show illuminated area equal to the existing raster configuration without any input provided [No input was connected at all until issue resolved] and on menu choices, red and blue would illuminate faintly.)
I couldn't figure out the issue with reseats and cleaning boards and testing so I did a full 100% complete reset on the projector.
All the issues have been resolved, HOWEVER, I now am unable to move the red and blue rasters left and right from the center in any convergence menu. Up and down work.
Green will work in up down left and right via the convergence service menu.
I've poured over the manual and reviewed all settings and menus.
What am I missing or doing wrong?
I can't seem to figure it out Any thoughts on this?
Thanks in advance!
|
|
Back to top |
|
|
Tim in Phoenix
Joined: 21 Oct 2006 Posts: 4379 Location: Phoenix
|
Link Posted: Sat Mar 07, 2015 4:03 pm Post subject: |
|
|
Hello
Static horizontal convergence is delivered thru the HDM; you have transposed the red and blue yoke cables. Put them back correctly and all should work.
|
|
Back to top |
|
|
CSX
Joined: 11 Feb 2015 Posts: 142 Location: Ohio
|
Link Posted: Sat Mar 07, 2015 4:12 pm Post subject: |
|
|
Yep.
That did it. Thanks much!
What an oversight.... I'm almost ashamed lol.
|
|
Back to top |
|
|
Curt Palme CRT Tech
Joined: 08 Mar 2006 Posts: 24303 Location: Langley, BC
TV/Projector: All of them!
|
Link Posted: Sat Mar 07, 2015 4:16 pm Post subject: |
|
|
Try spending an hour troubleshooting that.. after having worked on at least 200 Marques...LOL!
|
|
Back to top |
|
|
|
|