|
|
|
View previous topic :: View next topic |
Author |
Message |
newjoe1
Joined: 16 Dec 2014 Posts: 1
|
Link Posted: Tue Dec 16, 2014 12:27 pm Post subject: Front Projector calibration Epson Eh-tw 9200 |
|
|
Hi,
my name is Gerald Paul. With the beginning of this month i am using chromapure standard with an irite display 3 oem.
After a few evenings of measuring and trying to understand the chromapure workflow i have a few questions.
As Manuual for measuring is in use Chromapure grayscale and color calibration for Dummies.
Chapter 2.2.2.11
First Time White Balance Modul, 100% White Pattern is in use, but in picture above in the manual settings in White Blance Modul show 80%. Has it be set manually at 100% or leave it as declared on 80% and if yes why should it be on 80%?
After Calibrate my Front Projector with gamma settings too i switched back to White Balance Modul to control and setup the 2 Point grayscale with 80% and 20% test Pattern. All was fine, the Delta E differences were below 2. After that i setup the colors with CMS modul of my Epson and Chromapure. Then the final procedure follows the Post Calibration Grayscale Measuring and here the measurings 10 - 30 IRE were far from good, 5 - 6 Delta e Values. I dont understand that than measuring again in White Balance Modul for 20 IRE shows again an Delta E Value under 2.
What is wrong?
Kal could you help?
Regards
Gerald
|
|
Back to top |
|
|
kal Forum Administrator
Joined: 06 Mar 2006 Posts: 17860 Location: Ottawa, Canada
TV/Projector: JVC DLA-NZ7
|
Link Posted: Tue Dec 16, 2014 1:25 pm Post subject: Re: Front Projector calibration Epson Eh-tw 9200 |
|
|
newjoe1 wrote: |
Chapter 2.2.2.11
First Time White Balance Modul, 100% White Pattern is in use, but in picture above in the manual settings in White Blance Modul show 80%. Has it be set manually at 100% or leave it as declared on 80% and if yes why should it be on 80%? |
The 80% in the picture doesn't matter. It's the pattern that you display that matters. The 0-100% range you can select is for reporting purposes (if you want to report the results).
Quote: | After Calibrate my Front Projector with gamma settings too i switched back to White Balance Modul to control and setup the 2 Point grayscale with 80% and 20% test Pattern. All was fine, the Delta E differences were below 2. After that i setup the colors with CMS modul of my Epson and Chromapure. Then the final procedure follows the Post Calibration Grayscale Measuring and here the measurings 10 - 30 IRE were far from good, 5 - 6 Delta e Values. I dont understand that than measuring again in White Balance Modul for 20 IRE shows again an Delta E Value under 2. |
I would contact Tom at support@chromapure.com and send him your complete results as an attachment - without the results it's impossible to help. Tom is best positioned to assist.
Kal
_________________
Support our site by using our affiliate links. We thank you!
My basement/HT/bar/brewery build 2.0
|
|
Back to top |
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum
|
Forum powered by phpBB © phpBB Group
|
|