CurtPalme.com Home Theater Forum

[NinjaAsok]

Register to remove this ad. It's free!

Got a Barcographics 808s setup working fine in 2D, 1080p with a HDFury3 module today...

Thinking of getting the 3D-theatre module.. would this be a good setup.... ?

Any special stuff to consider ?

// Regards
// NinjaAsok

[kal]

Nope, should work fine. Your BG808s supports 720p/120 so you could run it at that higher 120Hz 3D refresh rate too instead of 60Hz. It's set by DIP switch #1.

To order see: http://www.curtpalme.com/3DTheatre.shtm

Kal

[kal]

Nope, should work fine. Your BG808s supports 720p/120 so you could run it at that higher 120Hz 3D refresh rate too instead of 60Hz. It's set by DIP switch #1.

To order see: http://www.curtpalme.com/3DTheatre.shtm

Kal

[NinjaAsok]

Wondering... whats the better solotion to keep using the HDFury3 with 3D-Theatre or replace them both
with the new HDFury4 (3dfury)..

Is the 3D fuctions built into the HDFury4 as good os the once in the 3D-Theatre ?

// NinjaAsok

[Tom.W]

[AVphile]

Do you not find the geometry a bit stretched at 1080p60?
I run either 900p72 or 1080p48 and find that is still pushing it. The picture us not very linear horizontally and there is at least 5% overscan.
You might have the same problem at 720p120.