CurtPalme.com Home Theater Forum

[Kevink]

Register to remove this ad. It's free!

I just installed a new Moome XG-FULLHD HDMI V1.3 card into an NEC XG-135. When powering on the projector, there is a brief flicker of the two red lights above the HDMI inputs and then nothing. None of the lights turn on. This is true when the card is in either the B and C slots.

The projector continues to function beautifully via RGB.

When I connect a DVD player to the pj via an HDMI cable, the green connection light above and between the two HDMI inputs lights up, but that's it.

Needless to say, I am not getting any kind of image.

I have fresh batteries in the remote. Nothing I do with the remote seems to change the situation.

Do I have a faulty card or am I failing to do something obvious with either the card or the pj? Any suggestions would be greatly appreciated. Thank you.

ps Where does one find an email address for Moome?

[Curt Palme]

Try a BluRay player with HDMI output set to 480p with a short cable, say 6' or so. BR to Moome directly, nothing inbetween. See if that works. If not, then I'd say you have a bad card.

[Curt Palme]

Try a BluRay player with HDMI output set to 480p with a short cable, say 6' or so. BR to Moome directly, nothing inbetween. See if that works. If not, then I'd say you have a bad card.

[dturco]

On the remote push the #1 button if nothing happens push the #2 button. This tells the Moome card which HDMI input to read. Have your source on when doing this.

Hope that cures it, if not I have no idea.

[Kevink]

Thanks for the suggestions. Unfortunately, the card is still dark.

Anyone know the shipping address for returns to Moome?

Thank you!