View previous topic :: View next topic |
Author |
Message |
paiaboy7
Joined: 15 Aug 2008 Posts: 65
|
Link Posted: Mon Nov 26, 2018 8:59 pm Post subject: NEC XG52 shutoff and error code |
|
|
I have a NEC XG52 CRT projector currently not working. As soon as you try to turn on the power, it starts to power up then just immediately shuts itself off. It will cycle a couple of times trying to turn on but nothing else happens. It was working fine then this issue came up all of a sudden. The picture shows the error code that comes up on the rear display of the projector. Any suggestions? Thanks!
Description: |
|
Filesize: |
54.99 KB |
Viewed: |
3831 Time(s) |
|
|
|
Back to top |
|
|
Curt Palme CRT Tech
Joined: 08 Mar 2006 Posts: 24305 Location: Langley, BC
TV/Projector: All of them!
|
Link Posted: Tue Nov 27, 2018 4:52 am Post subject: |
|
|
Is that a CC error or FC?
|
|
Back to top |
|
|
paiaboy7
Joined: 15 Aug 2008 Posts: 65
|
Link Posted: Wed Nov 28, 2018 1:20 am Post subject: |
|
|
It seemed like a cc but the bottom segment of the first c wasn't lit up.
|
|
Back to top |
|
|
Curt Palme CRT Tech
Joined: 08 Mar 2006 Posts: 24305 Location: Langley, BC
TV/Projector: All of them!
|
Link Posted: Wed Nov 28, 2018 11:26 pm Post subject: |
|
|
A really tough call then. It could be FC, which is a problem on the +15 volt line. That could be almost any board in the set, and is very hard to troubleshoot.
I have no more XG parts at this point other than remote controls, so it will be up to a scrap set that someone might have here to get you going again.
http://www.curtpalme.com/docs/NECXG_Error_Codes.pdf
|
|
Back to top |
|
|
paiaboy7
Joined: 15 Aug 2008 Posts: 65
|
Link Posted: Thu Nov 29, 2018 12:01 am Post subject: |
|
|
Thanks for checking. Is CC an easier fix?
|
|
Back to top |
|
|
pcheadaches
Joined: 09 Dec 2013 Posts: 62
|
Link Posted: Thu Nov 29, 2018 12:25 am Post subject: |
|
|
Try reseating the system board a few times.
|
|
Back to top |
|
|
Curt Palme CRT Tech
Joined: 08 Mar 2006 Posts: 24305 Location: Langley, BC
TV/Projector: All of them!
|
Link Posted: Thu Nov 29, 2018 12:34 am Post subject: |
|
|
CC is a system board error. I've never had that before, but i guess it's possible. Again, I have no parts, and the most common failure on XGs has been the system board, so finding a working system board will be tough.
Might be the time to go digital perhaps?
|
|
Back to top |
|
|
paiaboy7
Joined: 15 Aug 2008 Posts: 65
|
Link Posted: Thu Nov 29, 2018 6:07 pm Post subject: |
|
|
pcheadaches wrote: | Try reseating the system board a few times. |
Thank you I'll try that
|
|
Back to top |
|
|
|
|