View previous topic :: View next topic |
Author |
Message |
km987654
Joined: 25 Jul 2007 Posts: 2857 Location: Australia
TV/Projector: Barco BG809s
|
Link Posted: Tue Jan 12, 2016 9:21 pm Post subject: |
|
|
Looks like you are changing a splitter.
Could you have a Frame problem?
|
|
Back to top |
|
|
huggy
Joined: 02 Aug 2008 Posts: 927 Location: Melbourne,Australia
|
Link Posted: Tue Jan 12, 2016 9:26 pm Post subject: |
|
|
Frame problem?
_________________ Proud owner of stacked 909's on a 12 ft wide 16:9 screen.
|
|
Back to top |
|
|
km987654
Joined: 25 Jul 2007 Posts: 2857 Location: Australia
TV/Projector: Barco BG809s
|
Link Posted: Tue Jan 12, 2016 9:37 pm Post subject: |
|
|
huggy wrote: | Frame problem? |
If the splitter is not the issue and everything else works but still no HV then perhaps its the Frame. Also something has caused two quad failures.
Just a thought.
|
|
Back to top |
|
|
huggy
Joined: 02 Aug 2008 Posts: 927 Location: Melbourne,Australia
|
Link Posted: Fri Jan 15, 2016 1:13 pm Post subject: |
|
|
Ok after 2 quads, 1 splitter and an smps all is working on both pjs finall .
But i have an issue with setup. I set raster, convergance and phase all to 50 and have centre cross hatch perfectly aligned with centre point of screen. Unfortunately the left hand side of screen on one pj is inside screen by about 5 inches, right is good but i just cant figure out how to fix it.I have the same issue on the other pj but opposite side. Its been a while since ive set these up so im lost as to what the issue is. Im sure its something simple but ive drawn a blank.
Anyone?
Dave
_________________ Proud owner of stacked 909's on a 12 ft wide 16:9 screen.
|
|
Back to top |
|
|
gregstv
Joined: 27 Aug 2007 Posts: 628 Location: Australia
|
Link Posted: Fri Jan 15, 2016 10:10 pm Post subject: |
|
|
How is your horizontal linearity? Can you post a picture of the problem.
|
|
Back to top |
|
|
|
|