I recently installed an HDFury2 in my system. When I connect the HDMI cable from either the BD player or the HD satellite receiver into the Fury and then directly to my projector, I get a good picture. When I connect the Fury into the RGB input of the 2000, my pictures is a bit out of synch. I'm outputting thru an RGB cable directly. It's like the old B/W TV's where you had to make an adjustment in the vertical or horizontal holds. I'm inputting into a Marquee 9500 projector.
Link Posted: Thu Jul 23, 2009 12:11 am Post subject:
Sorry for the late reply, I missed this in the new posts section.
Can you describe "a bit out of sync" a bit more in detail. if the picture is not quite stable than the following may help:
Open the case by removing the four screws at the bottom and move the jumper from JP5 to JP6, when it is what I think it is that should clean up the picture, if needed you can turn potmeter P3 a bit to clean it up some more.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum